Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Turn the controller over, exposing the three screws on the back. Use a 6mm screwdriver to remove these screws.
-
Carefully slide and pull the two parts of the controller shell apart, exposing the innards.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Now that the top of the controller is exposed, the orange, side buttons can easily slide out.
-
Realign the buttons over the sensors/clean the sensor contacts.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a spudger to remove the top frame.
-
Take off the plate.
-
Remove the rubber buttons.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Pull the circuit strip through the new space.
-
Realign the top and bottom of the controller.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Return the buttons to the top of the controller.
-
Snap the frame back into place.
-
Screw the screws.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.