Einleitung
If the button on an Atari Flashback 2 console is sticking or broken, then it will need to be cleaned or replaced. This guide covers the steps necessary to disassemble the console in order to access the buttons to do so.
Was du brauchst
-
-
Using the screwdriver and PH1 bit, unscrew the five 10.0 mm screws.
-
-
-
-
Use a PH1 screwdriver to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Washington State, Team S1-G2, Hope Fall 2018 Mitglied von Washington State, Team S1-G2, Hope Fall 2018
WSU-HOPE-F18S1G2
4 Mitglieder
11 Anleitungen geschrieben
Ein Kommentar
Hello. I just bought a used atari flashback 2 and when I turn it on it seems that the power button is a little tricky. I wiggle the button in and out and half way etc. then sometimes I can get it to turn on. Once on, the video 'pulses' on and off and a pulsing sound is noticeable. Is it just a faulty power button or is it something worse like a power regulator. I've taken it apart and all seems to be ok looking ie. no burnt fuses etc. Can you help? ~Brad Beachin~
