Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
If the speakers aren't working... install new ones! This guide shows you how to change out old speakers that may not be working right.
Was du brauchst
-
-
Turn the device upside down.
-
Apply constant pressure to the base of your Audiovox, while holding the plastic casing until the casing is completely removed.
-
-
-
-
Using a Phillips #1 screwdriver, remove the screw found in the middle of the board.
-
-
-
Slide a plastic opening tool along the rim of the faulty speaker where it meets the plastic casing.
-
-
-
Using your thumb, applying constant pressure, pull back the plastic tab towards the speaker and away from the metal bracket.
-
Simultaneously insert a Phillips #00 screwdriver into the square hole on the underside of clock and push through to lift the metal bracket off of the plastic tab.
-
-
-
Pull up on the metal brackets, found on either side, until the speaker is completely removed. Removing the speaker is rather challenging. Don't get discouraged if it takes multiple attempts!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.