Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
The purpose of this guide is to show you how to open up your Audiovox. Once inside, you will be able to check out all of the different internal components, and, if needed, begin repair!
Was du brauchst
-
-
Begin by applying constant pressure to the base of your Audiovox while holding the plastic casing. Do this until the plastic casing is completely removed.
-
-
-
Insert a Phillips #1 screwdriver into the hole at the corner of the base and remove the screw.
-
Repeat this step for the remaining other three screws.
-
-
-
-
Gently pull off the top panel of the Audiovox, as shown in the picture, to ensure that the panel detaches properly.
-
-
-
Using a Phillips #1 screwdriver, remove the screw found in the middle of the board.
-
-
-
Gently, as to not disconnect any of the attached wires, pull back the board to view the soldered connections (on the other side) as well as the internal components.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.