Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using your hands, remove the blower tube and clamshell.
-
To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using a Phillips #2 screwdriver, remove the ten 20 mm screws in the orange casing.
-
Use your hands to lift off the side of the orange casing with the screws facing you.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the switch.
-
Remove the 2 black and white wires with blue casings from the switch.
-
Using your hands, push in the sides of the switch and slide out the wires.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two 20 mm Phillips #2 screws that are holding in the power cord (located at the bottom of the leaf hog).
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Slide the power cord support off the power cord in the direction of the leads.
-
Use your hands to pull the power cord out of the device with the lead end coming out last.
-