Einleitung
This guide will show how to replace the transmission of Black and Decker PS-1800.
Was du brauchst
-
-
Lay the drill on its side, assuring that the screw holes are facing upwards.
-
Remove seven 12 mm screws using a Phillips #00 screwdriver.
-
-
-
Locate the motor at the top left hand corner.
-
Carefully disconnect the red and black wires attached to the motor.
-
-
-
-
Unscrew the torque adjuster from the transmission by removing the screws highlighted in the lefthand picture.
-
-
-
Align the new transmission gears with the motor’s gears.
-
Reattach the transmission and motor by rescrewing the initial screws.
-
-
-
Reconnect the torque adjuster to the transmission by following the procedure seen in step 6.
-
-
-
Reconnect black and red wires onto the motor and place the motor, transmission and torque adjuster back onto their initial location.
-
-
-
Reconnect the clamshell.
-
Press trigger to make sure the new transmission works.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
IUPUI, Team 2-3, Baechle Fall 2016 Mitglied von IUPUI, Team 2-3, Baechle Fall 2016
IUPUI-BAECHLE-F16S2G3
5 Mitglieder
6 Anleitungen geschrieben
