Einleitung

This guide shows how to remove the side button used to browse through the menus on the RIM BlackBerry 7290.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Apply pressure to the lock button on the back of the device.
    • Apply pressure to the lock button on the back of the device.

    • Slide the battery cover down towards the bottom of the device, revealing the battery compartment.

    Kommentar hinzufügen

  2. Locate groove along the right side of the battery compartment.
    • Locate groove along the right side of the battery compartment.

    • Remove battery by prying between the battery and the groove.

    Kommentar hinzufügen

    • Slide the SIM card holder to the left to unlock the SIM card.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Lift the SIM card holder up.

    • Gently remove the SIM card from the SIM card holder by sliding the card along the railing.

    Kommentar hinzufügen

    • Locate the four screws along the perimeter of the back casing.

    • Remove the four top screws using a T-6 torx screwdriver.

    • The top four screws are .413 inches.

    Kommentar hinzufügen

    • Locate two screws within the lower edge of the inner compartment.

    • Remove the two bottom screws using a T-6 torx screwdriver.

    • The bottom two screws are .2 inches in length.

    • The second picture displays the device after the six screws have been removed.

    Kommentar hinzufügen

    • Use the plastic opening tool to apply pressure on the two clips that are located at the bottom of the phone.

    Kommentar hinzufügen

    • Remove the back casing from the phone by lifting the unhooked portion, then slide the casing towards the top of the device.

    • Make sure all clips holding the case together are unhooked, so no damage is caused to the case.

    Kommentar hinzufügen

    • Locate on the backside of the phone, a screw towards the top of the device.

    • Using a T-6 screwdriver, remove the screw.

    • After the screw has been removed, carefully lift the side button brace to reveal the side button.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jschutt

Mitglied seit 05.11.2009

70 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team 19-6, Maness Fall 2009 Mitglied von Cal Poly, Team 19-6, Maness Fall 2009

CPSU-MANESS-F09S19G6

5 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 6

Insgesamt: 3,472