Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Follow this guide to install the trackball in the Blackberry Pearl 8100.
Was du brauchst
-
-
Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.
-
-
-
Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.
-
-
-
Using the spudger, pry off the small portion of the casing located at the bottom of the phone.
-
-
-
-
Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.
-
-
-
Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.
-
-
-
Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.
-
-
-
Remove the larger chrome ring holding the track ball in place by using the spudger to gently wedge the top ring away, approaching from the front face.
-
-
-
Remove the smaller chrome inner ring surrounding the trackball; it should be able to be simply lifted by hand.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
Ein Kommentar
why dissasemble the entire device, just remove the chrome ring....