Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Use this guide to replace the bottom motherboard of your device.
Was du brauchst
-
-
Flip speaker over so that the bottom is facing up.
-
Using the blue spudger, lift the gray foam up and slowly peel it off with your hand.
-
-
-
Using the screwdriver, unscrew three screws.
-
Detach the bottom cover from the rest of the speaker by pulling the two in opposite directions.
-
-
-
-
Remove the two screws connecting the motherboard to the bottom cover of the speaker.
-
Remove the bottom cover.
-
-
-
Using the blue plastic opening tool, pry up the small black clamp connecting the AUX/USB port to the lower circuit board.
-
Remove the AUX/USB port from the device.
-
-
-
Remove the yellow tape over the location where the ribbon from the central speaker meets the bottom circuit board.
-
Use the blue plastic opening tool to pry up the black latch holding down the ribbon.
-
Remove the motherboard from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team S6-G2, Remmell Fall 2017 Mitglied von USF Tampa, Team S6-G2, Remmell Fall 2017
USFT-REMMELL-F17S6G2
4 Mitglieder
4 Anleitungen geschrieben
42 Kommentare
I need the ribbon because it is damage, can you sell one to me?
My email is ttegil@hotmail.com can you send me the way I can buy it.
Kind regards
Hello do toi fond thé ribbon because i have thé same problème .
M'y email adresse thualromain44.rt@gmail.com
Thanks you
Hi I need bottom circuit board for bose revolve , could you sale it for me. mail: seawolf1974@mail.ru , delivery to Spain
kindly regards
