Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Store

Einleitung

Replacement Parts Finder:

http://www.service.braun.com/home.asp?rg...

Contact information

Braun Consumer Service

Phone: 1-800-BRAUN-11 (1-800-272-8611)

Ersatzteile

Keine Ersatzteile angegeben.

  1. Soldering is required to install this battery one or two batteries may be required verify how many you need before you order
    • Soldering is required to install this battery one or two batteries may be required verify how many you need before you order

    Anleitung passt auch für Syncro Typ 5492, Modell 7540

    Garofalo - Antwort

  2. First pry the left side of the cover off, then pry the right side of the cover off before removing. Trying to pry the cover off from only one side will result in breaking the plastic tabs. First pry the left side of the cover off, then pry the right side of the cover off before removing. Trying to pry the cover off from only one side will result in breaking the plastic tabs.
    • First pry the left side of the cover off, then pry the right side of the cover off before removing. Trying to pry the cover off from only one side will result in breaking the plastic tabs.

    First you must remove the very bottom cover. Where the electrical plug goes in. Then the covers practically fall into your hand(s).

    Raoul F Lange - Antwort

  3. Pull the side covers off from the bottom, they hinge from the top and will come off freely once you rotate them up and away from the body starting at the bottom.
    • Pull the side covers off from the bottom, they hinge from the top and will come off freely once you rotate them up and away from the body starting at the bottom.

    Must remove the very bottom cover first, where the electrical plug goes in.

    Raoul F Lange - Antwort

  4. You will need a T9 hex screw driver. You will need a T9 hex screw driver.
    • You will need a T9 hex screw driver.

    die freigelegte Schalterschale “6” keinesfalls betätigen - federn fliegen ! - den schräg liegenden Hebel mit dem linken Daumen halten, mit schmalem Pinsel entstauben. Zum Lösen von Stoppelresten / staub Scherkopfreiniger aufsprühen , ich benutze “Multistar”, den sanftesten Schmutzlöser ( im Internet suchen, )

    Garofalo - Antwort

    • R17 AA NiMh Battery With Pin Tabs 1650 Mah 1.2V Battery Measures .559" x 1.97", 14.2mm x 50mm

    Vor Auslöten der Akkus ( beim 7540) Pluspole markieren, auch auf der Platine, sind dort nicht angezeichnet.

    Garofalo - Antwort

    • Replacing the batteries will not always repair the shaver, the circuit board may be bad, if the indicator lights on the circuit board do not light up when plugged in the circuit board is most likely bad, you should replace the entire circuit board and battery assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

15 weitere Nutzer haben diese Anleitung absolviert.

mayer

Mitglied seit: 04.01.2010

677.112 Reputation

11 Anleitungen geschrieben

Team

MacHale Enterprises Mitglied von MacHale Enterprises

Business

1 Mitglied

16 Anleitungen geschrieben

Great tutorial. It was all I needed, since I wasn't sure how to get the case open. Thanks!

mikebailey - Antwort

Thanks for the tutorial! Mine had intermittent problem with the on/off switch and I was googling how to open the case. Easy and simple, bets razor I’ve had and not willing to change :D

Tero Kortetmäki - Antwort

Thanks for the tutorial… but it is a T8 Torx at least in the Model 7570. I just had to take out the recharchable batteries to get mine working properly again.

A Krueger - Antwort

Danke für die übersichtliche Anleitung, hat mir gut geholfen. Die wichtige Frage ist immer:

Wie geht ‘s Gehäuse auf. ?

Garofalo - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 3

Letzten 7 Tage: 41

Letzten 30 Tage: 202

Insgesamt: 16,182