Ersatzteile

Kein Ersatzteil erforderlich.

  1. To remove the outer casing, use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides of the device.
    • To remove the outer casing, use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides of the device.

  2. Using the Metal Spudger, carefully pry  each side of the rubber casing away from the device.
    • Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.

    • A little resistance should be felt, but not enough to bend the spudger.

    • To remove the inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the top side of the device.

    • Carefully lift away the housing and replace the broken casing/component. Replace using the new casing.

    • To remove the motherboard, proceed to unscrew the 3 Phillips #00 bit type, 13mm long screws located on both sides of the motherboard.

    • Then, proceed to unscrew the 5 Phillips #00 bit type, 9mm long screws located on the face of the charging dock.

    • Disconnect the two 4-pin auxiliary button register cables connected on both sides of the motherboard.

    • Once disconnected, carefully remove the motherboard by pulling upwards.

    • To remove the button registers, unscrew the two Phillips #00 bit type, 6 mm screws found on both sides of the control registers.

    • Carefully remove the control registers from the housing of the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Erik Oliva

Mitglied seit 14.02.2018

607 Reputation

6 Anleitungen geschrieben

Team

USF Tampa, Team S2-G1, Eyestone Spring 2018 Mitglied von USF Tampa, Team S2-G1, Eyestone Spring 2018

USFT-EYESTONE-S18S2G1

4 Mitglieder

6 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 11

Insgesamt: 62