Ersatzteile

Kein Ersatzteil erforderlich.

  1. To remove the outer rubber casing use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides, found on the bottom part of the device.
    • To remove the outer rubber casing use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides, found on the bottom part of the device.

  2. Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.
    • Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.

    • A little resistance should be felt, but not enough to bend the spudger.

  3. Kostenloser Versand für alle Bestellungen über 100 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um
  4. To remove the hard inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the subwoofer on the top side of the device.
    • To remove the hard inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the subwoofer on the top side of the device.

  5. Carefully lift away the broken sub-woofer plate of the device. Replace with functioning sub-woofer plate.
    • Carefully lift away the broken sub-woofer plate of the device. Replace with functioning sub-woofer plate.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Erik Oliva

Mitglied seit: 14.02.2018

607 Reputation

6 Anleitungen geschrieben

Team

USF Tampa, Team S2-G1, Eyestone Spring 2018 Mitglied von USF Tampa, Team S2-G1, Eyestone Spring 2018

USFT-EYESTONE-S18S2G1

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 35