Einleitung

The battery is essential and can wear out or stop working over time. This guide will show you how to properly remove it.

Tech Tip: this Replacement guide will require the use of a soldering iron to remove solders, so check out the soldering guide if you're unfamiliar with the process.

Remove three 8mm screws from the left side of the device.
  • Remove three 8mm screws from the left side of the device.

  • Remove four 8mm screws from the right side of the device.

Kommentar hinzufügen

Apply pressure on the SD card to pop it out of the port.
  • Apply pressure on the SD card to pop it out of the port.

  • Remove the card by pulling it out.

Kommentar hinzufügen

  • Press down on the top cover of the device and slid it towards you until you see a slight gap created.

  • Lift the top cover off.

Kommentar hinzufügen

  • Slide the body case back away from the bottom.

  • Pull up the body case to remove it from the bottom.

Kommentar hinzufügen

  • Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.

Kommentar hinzufügen

  • Lift the motherboard out of the casing.

Kommentar hinzufügen

  • Flip the motherboard over.

  • Desolder the two solder joints and remove the melted solder.

  • Beware of over heating the soldering kit will damage the logic board.

Kommentar hinzufügen

  • Apply the desoldering pump to remove the melted part from the motherboard (press the button to release it).

  • Pull the battery from the motherboard.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tuong Ngo

Mitglied seit 15.02.2018

85 Reputation

1 Anleitung geschrieben

Team

USF Tampa, Team S17-G6, Boczar Spring 2018 Mitglied von USF Tampa, Team S17-G6, Boczar Spring 2018

USFT-BOCZAR-S18S17G6

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 2

Letzte 30 Tage: 4

Insgesamt: 146