Einleitung

This guide will walk you through the process of replacing the faceplate on a Brother PT-D200.

Ersatzteile

Kein Ersatzteil erforderlich.

Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.
  • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

Kommentar hinzufügen

Remove the six AAA batteries.
  • Remove the six AAA batteries.

Kommentar hinzufügen

Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.
  • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

Kommentar hinzufügen

Close the back cover and then flip the device over and separate the top half from the bottom half as shown.
  • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

  • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

Kommentar hinzufügen

Gently pull out the ribbon cable from the circuit board.
  • Gently pull out the ribbon cable from the circuit board.

  • The ribbon cable is very fragile.

Kommentar hinzufügen

Remove two-pin plastic connector from the circuit board.
  • Remove two-pin plastic connector from the circuit board.

  • Gently pull the two-pin connector from the circuit board to avoid damaging the board.

Kommentar hinzufügen

On the top portion of the device there are four grey clips locking the faceplate in place.  The two top clips are circled in the image. The two others are located in the other corners of the device.
  • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

Kommentar hinzufügen

Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off. Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.
  • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

[deleted]

Mitglied seit 24.01.2014

301 Reputation

3 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 4

Insgesamt: 358