Einleitung

Follow this guide to remove a bush pump's head and handle for repair or replacement. Be sure to use at least two people when following this guide to prevent injury, as the pump head can be heavy.

  1. Test pump performance by pumping 40 strokes.
    • Test pump performance by pumping 40 strokes.

    • An effective pump should return at least 10 liters.

    Kommentar hinzufügen

  2. Remove the two pins connecting the handle to the slider.
    • Remove the two pins connecting the handle to the slider.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Pull the two lever arms away from the slider.

    Kommentar hinzufügen

    • Lift the two pins attaching the pump frame to the head and handle up, off of the pump frame.

    Kommentar hinzufügen

    • Throughout this step, make sure you support the handle and head with at least three hands.

    • Slide the bearing rod out of the head.

    • Inspect the bearing rod and head for any wear or tear.

    Kommentar hinzufügen

    • Remove the head and handle, and place them on a clean surface to prevent contamination.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jake Devincenzi

Mitglied seit 18.04.2011

106.622 Reputation

57 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 95