Einleitung

This guide will help you step by step to reach and replace the inner eyepiece of canon EOS 30.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Remove the two 4.8 mm black screws above the lens on the front of the camera.
    • Remove the two 4.8 mm black screws above the lens on the front of the camera.

    Kommentar hinzufügen

  2. Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
    • Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.

    Kommentar hinzufügen

    • Remove the 4.8 mm black screw on the left side of the camera.

    Kommentar hinzufügen

    • Remove the front panel by lifting it away from the camera's body.

    Kommentar hinzufügen

    • Slide the outer eyepiece upward to remove it.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Remove the two 4.75 mm black screws located on the top of the camera.

    Kommentar hinzufügen

    • Remove the four 4.3 mm black screws near the bottom corners of the eyepiece at the back of the camera.

    Kommentar hinzufügen

    • Slowly separate the top panel from the camera by pushing it upward.

    • Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.

    Kommentar hinzufügen

    • Remove the two 9.5 mm black screws that attach the inner eyepiece to the camera's body and remove the eyepiece.

    Kommentar hinzufügen

    • Remove the two 4.3 mm silver screws on each side of the inner eyepiece.

    Kommentar hinzufügen

    • Separate the inner eyepiece into three parts.

    • The outer piece (left) has a small gear, which can easily fall off and get lost.

    Kommentar hinzufügen

    • Remove the two 3.6 mm black screws from the outer piece.

    Kommentar hinzufügen

    • Remove the glass panel and replace it.

    • When removing the glass panel make sure not to separate the small rubber piece attached around the frame.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Jackie

Mitglied seit 17.04.2011

218 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 8-8, Regan Spring 2011 Mitglied von Cal Poly, Team 8-8, Regan Spring 2011

CPSU-REGAN-S11S8G8

5 Mitglieder

11 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 4

Insgesamt: 2,362