Einleitung

This guide will show users how to access the rear button contact in order to replace or clean the button contacts. It is not necessary to remove the LCD or speaker in order to perform this guide.

Ersatzteile

Kein Ersatzteil erforderlich.

Peel back the rubber cover above the in/out ports to reveal two screw heads.
  • Peel back the rubber cover above the in/out ports to reveal two screw heads.

Kommentar hinzufügen

Remove both 5.4 mm screws using a Phillips #0.
  • Remove both 5.4 mm screws using a Phillips #0.

I just accidentally stripped one of those screws. Is there anything I can do or am I...screwed?

Casey Ayers - Antwort

Lift the in/out port plastic covering from the bottom where the backup battery used to be.
  • Lift the in/out port plastic covering from the bottom where the backup battery used to be.

Kommentar hinzufügen

Remove each 6.3 mm screw on either side of the viewfinder using a Phillips #0 screwdriver.
  • Remove each 6.3 mm screw on either side of the viewfinder using a Phillips #0 screwdriver.

Kommentar hinzufügen

Remove the three 4.8 mm screws on the bottom of the back plate using a Phillips #0.
  • Remove the three 4.8 mm screws on the bottom of the back plate using a Phillips #0.

Kommentar hinzufügen

Peel back the rubber covering next to the menu dial to access the screw.
  • Peel back the rubber covering next to the menu dial to access the screw.

  • Remove the single 3.4 mm screw using a Phillips #0.

Kommentar hinzufügen

The back panel can now fall off easily by turning the device upside down. Be sure to catch it so the data ribbons do not tear or tug.
  • The back panel can now fall off easily by turning the device upside down. Be sure to catch it so the data ribbons do not tear or tug.

Kommentar hinzufügen

Remove each data ribbon cable from the motherboard by applying pressure down towards the motherboard and gently sliding your thumb upwards on the slot where the cable meets the motherboard. This will raise a very small clip that locks the cable in place.
  • Remove each data ribbon cable from the motherboard by applying pressure down towards the motherboard and gently sliding your thumb upwards on the slot where the cable meets the motherboard. This will raise a very small clip that locks the cable in place.

  • The back panel is now free from the rest of the device.

Kommentar hinzufügen

Remove each of the four 4.8 mm screws holding the protective plate over the button contact ribbon cable. Remove each of the four 4.8 mm screws holding the protective plate over the button contact ribbon cable.
  • Remove each of the four 4.8 mm screws holding the protective plate over the button contact ribbon cable.

Kommentar hinzufügen

Free the blue data ribbon cable by firmly pressing your thumb over the black clasp at the end of the cable and sliding your thumb to the left. This will raise the clasp and free the cable. Free the blue data ribbon cable by firmly pressing your thumb over the black clasp at the end of the cable and sliding your thumb to the left. This will raise the clasp and free the cable.
  • Free the blue data ribbon cable by firmly pressing your thumb over the black clasp at the end of the cable and sliding your thumb to the left. This will raise the clasp and free the cable.

Kommentar hinzufügen

Pull back the rubber backing found underneath the blue ribbon cable.
  • Pull back the rubber backing found underneath the blue ribbon cable.

Kommentar hinzufügen

You can now use a brush to clean any built up residue beneath the buttons.
  • You can now use a brush to clean any built up residue beneath the buttons.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Mike Seed

Mitglied seit 22.09.2014

2.137 Reputation

8 Anleitungen geschrieben

Team

USF Tampa, Team 1-6, Hickman Fall 2014 Mitglied von USF Tampa, Team 1-6, Hickman Fall 2014

USFT-HICKMAN-F14S1G6

3 Mitglieder

8 Anleitungen geschrieben

Thank you for the great guide. Can you include one more step on the circular button as well? It will complete the guide by covering all the buttons in the back.

Also, do you have a recommendation on where to get a replacement button? My button is sticky.

Dat Chu - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 3

Letzte 7 Tage: 9

Letzte 30 Tage: 49

Insgesamt: 3,029