Einleitung

This guide shows you how to install a new LCD screen.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Kommentar hinzufügen

Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

Kommentar hinzufügen

  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

Kommentar hinzufügen

  • Turn Camera over.

  • Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

Kommentar hinzufügen

  • Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

Kommentar hinzufügen

  • Lay the camera on its back.

  • Unsolder the flash connection from the motherboard as noted by the blue circle.

Kommentar hinzufügen

  • Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

Kommentar hinzufügen

  • Pry off the small metal brace holding the LCD screen. (Push forward and slide toward the center)

Kommentar hinzufügen

  • Lift out the LCD screen.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Zach

Mitglied seit 04.04.2012

40 Reputation

8 Anleitungen geschrieben

Team

Cal Poly, Team 14-9, Forte Spring 2012 Mitglied von Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Mitglieder

12 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 4

Insgesamt: 897