Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide serves to replace a faulty flash mechanism.
Was du brauchst
-
-
Remove the knot on the wrist lanyard.
-
Remove the battery and the memory card.
-
-
-
Begin removing the screws on the bottom of the outer casing.
-
Next, remove the rest of the screws from the outer casing.
-
-
-
Open the "A/V Out Digital" cover. Remove the screw inside.
-
Gently pull off the back casing.
-
Remove the black "L" shaped piece of metal.
-
-
-
Remove the three screws that are holding the screen in place. Free the screen from the underlying components.
-
-
-
-
With the spudger, gently lift the black flap that is holding the wide ribbon cable wire in place.
-
Unplug the wide ribbon cable.
-
Unplug the narrow ribbon cable to free the LCD screen from the camera body.
-
-
-
Remove the L-shaped corner trim containing the picture button.
-
Carefully unplug the connection cable attached.
-
-
-
Pull the selector wheel from the top corner of the camera.
-
With a set of tweezers, carefully remove the ribbon cable connection.
-
-
-
With a metal spudger, gently pry up and remove the cable connection.
-
With a metal spudger, gently lift up black tab to remove ribbon cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 19-5, Maness SU 2012 Mitglied von Cal Poly, Team 19-5, Maness SU 2012
CPSU-MANESS-SU12S19G5
1 Mitglied
5 Anleitungen geschrieben
