Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Remove the two 2.9 mm screws from the side panel closest to the camera lens.
-
-
-
Pull the back panel away from the camera body, starting at the end with the function buttons.
-
-
-
Remove the front cover by gently pulling it away from the camera body.
-
-
-
-
Place the front cover, back cover, and wrist strap mount in a safe place until you are ready for reassembly.
-
-
-
Pull up the metal frame surrounding the LCD screen starting at the side of the camera.
-
-
-
Push the metal frame away from the metal tab using the spudger to detach the frame.
-
Rotate the metal frame upwards.
-
-
-
Carefully lift the metal frame from the camera.
-
Remove the black LCD screen, leaving the thin lens pieces in place.
-
-
-
Carefully pull on the orange connector ribbon to disconnect the LCD screen.
-
The LCD screen can be pulled out of the frame before disconnecting its connector ribbon.
-
-
-
Remove the metal frame on the side closest to the flash mechanism. This will expose the screw securing the flash assembly.
-
-
-
Use the spudger to carefully disconnect the flash assembly ribbon from the black connector lock.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 8-18, Maness Winter 2012 Mitglied von Cal Poly, Team 8-18, Maness Winter 2012
CPSU-MANESS-W12S8G18
4 Mitglieder
12 Anleitungen geschrieben
