Einleitung

The motherboard can be damaged because of overheat and a short circuit which can cause the camera to stop working. This guide will show how to replace the motherboard in the device.

  1. Remove two 2mm Phillips #00 screws on both sides of the camera.
    • Remove two 2mm Phillips #00 screws on both sides of the camera.

  2. Remove the 4mm Phillips #000 screw from the bottom.
    • Remove the 4mm Phillips #000 screw from the bottom.

    • Remove the front face panel of the camera.

    • Remove the rear panel of the camera by using hand with firm pressure.

    • The user interface panel, side and bottom panel of the camera may fall down by itself while you are taking the rear panel of the camera.

    • Remove the 3mm Phillips #000 screw from the top of the camera.

    • Pry the three golden ribbons off the motherboard using a plastic opening tool.

    • Use a plastic opening tool to flip up the retaining flap on the ribbon cable ZIF socket.

    • Once released, the small black tab will point straight away from the front face of the camera and the golden film will no longer be attached to the motherboard.

    • Unplug the small chip from the face of the camera using a pair of tweezers.

    • Remove the three 3mm Phillips #000 screws from the motherboard.

    • Remove the 3mm Phillips #000 screw from the rear face of the camera.

    • Remove the top panel from the camera.

    • Remove the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Faris Rezwan

Mitglied seit 21.05.2018

433 Reputation

2 Anleitungen geschrieben

Team

IUPUI, Team S1-G2, Harley Spring 2018 Mitglied von IUPUI, Team S1-G2, Harley Spring 2018

IUPUI-HARLEY-S18S1G2

7 Mitglieder

4 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 137