Einleitung

Removing the buttons might be necessary if a button is damaged. This guide will show how to remove all external buttons on the camera.

Ersatzteile

Kein Ersatzteil erforderlich.

The camera used to create these repair guides had a broken lens assembly.  As a result, the lens is sticking out in all of the photos, but it is important to note that this should not be the case with your camera.  The lens should retract itself back into the camera when it is turned off.
  • The camera used to create these repair guides had a broken lens assembly. As a result, the lens is sticking out in all of the photos, but it is important to note that this should not be the case with your camera. The lens should retract itself back into the camera when it is turned off.

  • Use your fingernail to slide the dark gray tab located on the bottom of the device towards the edge of camera.

  • Slide the light gray door away from the LCD screen and pull up to open the door.

  • Both battery and memory card should now be visible.

Kommentar hinzufügen

Rotate the small brown tab towards the edge of the camera.
  • Rotate the small brown tab towards the edge of the camera.

  • The battery should pop up.

Kommentar hinzufügen

  • Pull the battery straight out of the battery holder.

  • When putting the battery back in, make sure it is orientated the same as it was before.

Kommentar hinzufügen

  • Close light gray battery compartment door.

  • Remove the six 2.8 mm Phillips screws on the outside of the case. Two screws are found on each side of the camera, and the final two are found on the bottom.

Kommentar hinzufügen

  • Use your fingers to carefully pry off the back casing from the camera assembly. Casing should lift straight off.

Kommentar hinzufügen

  • Push the buttons out with your finger if they did not fall out while removing the casing.

  • Pull off the white plastic side piece if it did not fall out while removing the casing.

Kommentar hinzufügen

  • Remove the one 2.2 mm Phillips screw from the bottom of the camera.

  • Take off the print button.

Kommentar hinzufügen

  • Use your fingers to carefully pry off the front casing of the camera. The front casing should pull straight off.

Kommentar hinzufügen

  • Use the flat end of the spudger to lift open the white plastic latch on the front of the camera. Once the latch is lifted up, move the latch up towards the top edge of the camera.

  • Remove the top button assembly by pulling straight up.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

James Loy

Mitglied seit 06.10.2010

103 Reputation

7 Anleitungen geschrieben

Team

Cal Poly, Team 5-12, Maness Fall 2010 Mitglied von Cal Poly, Team 5-12, Maness Fall 2010

CPSU-MANESS-F10S5G12

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,293