Einleitung

You need to remove the casing before you can start getting into any internal parts of the Camera. This can also be a good start to helping the camera dry out in case of a water accident.

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the battery and SD Card from their slots.  Leaving these in could cause the battery to ground and ruin the electronics.
  • Remove the battery and SD Card from their slots. Leaving these in could cause the battery to ground and ruin the electronics.

  • Unscrew the six screws on the casing. Two are on the bottom as pictured; two more are on each side of the camera.

Kommentar hinzufügen

Pull the lanyard mount off of the camera using a spudger or your fingers.
  • Pull the lanyard mount off of the camera using a spudger or your fingers.

Kommentar hinzufügen

  • Find the line that separates the casing into its two halves. Hold each half seperately, and gently pull apart.

  • Note that there is a small metal clip holding the two halves together. It might help to press down on the back half (indicated) while pulling upward slightly on the front half.

Kommentar hinzufügen

  • Take hold of the inside of the camera, and gently pull away from the back casing.

Kommentar hinzufügen

  • Remove the square, clear, rubber protector from the front of the logic board. This is not necessary to remove, but can easily fall off and get lost during later steps.

Kommentar hinzufügen

  • When you reassemble the camera, make sure the switch on the casing (pictured left) matches the position of the switch on the camera internals.

  • The black viewfinder padding (pictured right) can easily fall off the casing. Make sure you don't lose it when moving around parts.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Curtis Wagner

Mitglied seit 10.04.2010

29 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team 25-85, Amido Spring 2010 Mitglied von Cal Poly, Team 25-85, Amido Spring 2010

CPSU-AMIDO-S10S25G85

4 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 3,377