Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
The shutter button is one of the most commonly used buttons on a camera. Therefore, it is also the most likely to break.
Was du brauchst
-
-
Slide open the battery cover.
-
Push the small orange tab to the side so the battery can be removed.
-
-
-
Two Phillips screws need to be removed using a #00 Phillips screwdriver. The upper screw is under the USB port cover, which can simply be pulled away gently from the casing. the lower screw is visible on the panel.
-
The screws are different sizes. The .125 inch screw is located under the USB port cover. The 0.85 inch screw goes in the lower hole on the panel.
-
-
-
-
Remove two .085 inch Phillips screws from the left side of the camera using a #00 Philips screwdriver.
-
-
-
Remove three .15 inch Phillips screws from the bottom of the camera using a #00 Phillips screwdriver.
-
-
-
Once the casing is unscrewed, hold the camera with one side facing down, and lift the opposite face of the casing to open it.
-
Remove the internal camera components and layout out all pieces on a clean surface.
-
-
-
Unscrew one .235 inch long Phillips screw using a #00 Phillips screwdriver from the top of the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Clemson, Team 2-1, Benson Fall 2014 Mitglied von Clemson, Team 2-1, Benson Fall 2014
CLEM-BENSON-F14S2G1
4 Mitglieder
9 Anleitungen geschrieben
