Einleitung

How to remove the outer casing of your Canon PowerShot SD870 IS.

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the wrist strap, if present.
  • Remove the wrist strap, if present.

  • Remove the lithium-ion battery.

Kommentar hinzufügen

Remove the two 4 mm Phillips #00 screws on the bottom of the camera. Remove the screw next to the wrist strap attachment. Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.
  • Remove the two 4 mm Phillips #00 screws on the bottom of the camera.

  • Remove the screw next to the wrist strap attachment.

  • Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.

Note: The PH000 bit from my iFixit toolkit fits the screws better than the PH00 described above. The 00 bit is too pointed to bottom out in the screw and therefore does not engage as well.

wayne - Antwort

Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.
  • Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.

With the camera I was repairing, to remove the front cover as shown below, it was necessary to first remove the two smaller screws on the opposite end of the body from the “A/V OUT DIGITAL” cover. That is . . . the screws shown in step 5 which in my camera also hold the front cover in place (design change apparently).

RWM

wayne - Antwort

Pull the front cover from the camera by  using gentle upward pressure. Pull the front cover from the camera by  using gentle upward pressure.
  • Pull the front cover from the camera by using gentle upward pressure.

Kommentar hinzufügen

Remove the two Phillips #00 screws from the flat end of the camera. Remove the black L-shaped side cover plate.
  • Remove the two Phillips #00 screws from the flat end of the camera.

  • Remove the black L-shaped side cover plate.

  • Remove the silver u-shaped retainer plate.

Kommentar hinzufügen

Slide the back casing off.
  • Slide the back casing off.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Zach pelley

Mitglied seit 19.04.2010

58 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team 10-45, Garner Spring 2010 Mitglied von Cal Poly, Team 10-45, Garner Spring 2010

CPSU-GARNER-S10S10G45

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 4

Insgesamt: 7,792