Canon PowerShot SD870 IS Outer Case Replacement

Einleitung

How to remove the outer casing of your Canon PowerShot SD870 IS.

Was du brauchst

Schritt 1 Outer Case

Canon PowerShot SD870 IS Outer Case Replacement, Outer Case: Schritt 1, Bild 1 von 1

Remove the wrist strap, if present.
Remove the lithium-ion battery.

Übersetzen

Schritt 2

Canon PowerShot SD870 IS Outer Case Replacement: Schritt 2, Bild 3 von 3

Remove the two 4 mm Phillips #00 screws on the bottom of the camera.
Remove the screw next to the wrist strap attachment.
Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.

Übersetzen

Note: The PH000 bit from my iFixit toolkit fits the screws better than the PH00 described above. The 00 bit is too pointed to bottom out in the screw and therefore does not engage as well.

wayne - 29. Dez 2016 Antwort

Schritt 3

Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.

Übersetzen

With the camera I was repairing, to remove the front cover as shown below, it was necessary to first remove the two smaller screws on the opposite end of the body from the “A/V OUT DIGITAL” cover. That is . . . the screws shown in step 5 which in my camera also hold the front cover in place (design change apparently).

RWM

wayne - 28. Dez 2016 Antwort