Flip the device over to the back side.
  • Flip the device over to the back side.

Kommentar hinzufügen

Slide the small switch on the back to "MAIN".
  • Slide the small switch on the back to "MAIN".

Kommentar hinzufügen

  • Slide the battery cover downwards.

  • Pull off the battery cover.

Kommentar hinzufügen

  • Pull the black tab to remove the battery.

Kommentar hinzufügen

  • Using the Phillips #00 screwdriver, remove the two screws near the top of the device.

Kommentar hinzufügen

  • Using the Phillips #00 screwdriver, remove the two screws located inside the battery compartment.

Kommentar hinzufügen

  • Partially separate the two halves of the case by inserting the tip of a small flat head screw driver into the space between the halves.

Kommentar hinzufügen

  • Pry the two halves of the case apart with the small flat head screwdriver.

Kommentar hinzufügen

  • Caution: be careful not to pull out the wires connecting the two halves of the outer case. These wires are necessary for the device to be able to function.

  • Lay the two halves of the outer case next to the central components as shown.

Kommentar hinzufügen

  • Using the #00 Phillips screwdriver, remove the screws from the corners of the screen. There are 3 screws total.

Kommentar hinzufügen

  • Lift the tab on the motherboard and pull out the ribbon cable.

  • After the ribbon cable is detached from the motherboard, the touch screen is completely separated from the device.

Kommentar hinzufügen

  • Locate the small grey ribbon cable towards the bottom of the device. It should be located above the battery slot. Pinch both sides of the ribbon cable and pull it out.

Kommentar hinzufügen

  • Locate the multicolored wire on the motherboard near the battery compartment. Pull on the wire by the base and lift to remove.

Kommentar hinzufügen

  • Use the Phillips #00 Screwdriver to remove the two screws from the green circuit board on the back case.

Kommentar hinzufügen

  • Remove the the three screws on the motherboard that are shown using the Phillips #00 Screwdriver.

Kommentar hinzufügen

  • Caution: do not break ribbon cables from the motherboard because this may cause damage to your device.

  • Flip the motherboard towards the front cover to expose the ribbon cables underneath.

Kommentar hinzufügen

  • Locate the two ribbon cables on the motherboard. Select one to remove first and then pinch either side of it and pull out to remove the ribbon cable. Do the same for the second.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Ryan Fernandez

Mitglied seit 03.04.2012

47 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 5-4, Forte Spring 2012 Mitglied von Cal Poly, Team 5-4, Forte Spring 2012

CPSU-FORTE-S12S5G4

6 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 1

Letzte 30 Tage: 8

Insgesamt: 778