Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will walk you through the following steps:
- Removing the bottom of the kettle
- Locating and identify the internal components
- Disconnecting the wiring from the internal components
- Removing the kettle power supply
Reassembly is as simple as reversing the steps!
Was du brauchst
-
-
The red circles identify the five (5) Phillips screws.
-
The green square identifies the ON/OFF Switch.
-
SECOND IMAGE: Remove the five (5) 3/8" Phillips screws from the base of the kettle using a #1 Phillips head screwdriver.
-
-
-
Using your hands, pry the base off the kettle. Open it like a clamshell: the ON/OFF switch will be the hinge point.
-
-
-
-
A: The power supply.
-
B: The two boil-dry protection switches, one on either side of the central black ring.
-
C: The power coupling. This fits into the baseplate when you place the kettle on it.
-
D: The thermostat. This is a little metal ring, half hidden by the switch cover.
-
E: The manual ON/OFF switch.
-
F: The indicator light.
-
G: The steam chamber. This heats the thermostat, which turns off the kettle automatically.
-
-
-
Take note of how the wires connect to the components to aid reassembly.
-
Remove the connectors (spaded lugs) from the circuit components as shown in the second image.
-
You should be able to remove each connector easily by hand. Pinch the lug between your fingers and pull in the direction of the attached wire.
-
If necessary, use needle-nose pliers to grasp the lug shank firmly. Gently pull the lug in the direction of the attached wire.
-
Gently bend the disconnected wires back and out of the work area.
-
-
-
Using a 7/32" nut driver, remove the hex nut that secures the power supply to the base of the kettle.
-
Using a pair of tweezers, remove the split-ring lock washer located under the nut. (It may be hard to see in low light.)
-
-
-
Using your hands, grasp the wire that is still connected to the power supply. Carefully lift the power supply off the threaded stud to which it was coupled.
-
Five (5) screws.
-
The kettle base.
-
One (1) 7/32'' hex nut.
-
One (1) 7/32" split-ring lock washer.
-
One (1) power supply unit.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
4 weitere Nutzer:innen haben diese Anleitung absolviert.
Angehängte Dokumente
2 Kommentare
The photographs and schematic were very helpful, but the problem was not with the Power Supply; the on-off switch lit up. I needed to remove the two other nuts at the yellow arrows and look more closely at the Boil Dry Protection Switches. I removed and replaced the metal plates and noticed that two white plastic pieces swung out into the space around the Power Coupling. Had I reset something? Regardless, after reconnecting wires and reattaching nuts and screws, the pot is back to working order. Thank you so much for posting this Fix It!