Connect Four Electronic Handheld Speaker Replacement

Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.

Einleitung

If your Connect Four Electronic Handheld does not make any sound, you may need to replace the speaker. This replacement guide will show you how to remove the back casing and remove the speaker. In addition, this guide will also show you how to re-solder the speaker wires.

Was du brauchst

Schritt 1 Ensure the device is off.

Connect Four Electronic Handheld Speaker Replacement, Ensure the device is off.: Schritt 1, Bild 1 von 1

Make sure the Connect Four Electronic Handheld is off by allowing it to shut off automatically.

Übersetzen

Schritt 2 Removing the battery casing.

Connect Four Electronic Handheld Speaker Replacement, Removing the battery casing.: Schritt 2, Bild 1 von 2

Connect Four Electronic Handheld Speaker Replacement, Removing the battery casing.: Schritt 2, Bild 2 von 2

Using a Phillips head screwdriver, remove the (9.1mm length) #2 screw in the middle of the battery casing.
Slide the cover off and remove the battery.

Übersetzen

Schritt 3 Removing/Replacing the Back Casing

Connect Four Electronic Handheld Speaker Replacement, Removing/Replacing the Back Casing: Schritt 3, Bild 1 von 2

Connect Four Electronic Handheld Speaker Replacement, Removing/Replacing the Back Casing: Schritt 3, Bild 2 von 2

Using a Phillips head screwdriver, remove the four (7.1mm- length) #3 screws that hold the back casing in place.
Carefully remove the back casing.
When removing the back casing, make sure not to rupture the wires that connect the speaker to the circuit board.

Übersetzen

Schritt 4 Replacing the speaker

Connect Four Electronic Handheld Speaker Replacement, Replacing the speaker: Schritt 4, Bild 1 von 3

Connect Four Electronic Handheld Speaker Replacement, Replacing the speaker: Schritt 4, Bild 2 von 3

Connect Four Electronic Handheld Speaker Replacement, Replacing the speaker: Schritt 4, Bild 3 von 3

If the speaker is in working condition, but the wires are broken or disconnected, skip this step and move on to step 5.
Locate the speaker on the back casing.
Using a spudger, wedge the speaker out of its place until it slides out.
Take the replacement speaker and wedge it back into its space.

Übersetzen

Schritt 5 Re-Soldering the Speaker Wire

Connect Four Electronic Handheld Speaker Replacement, Re-Soldering the Speaker Wire: Schritt 5, Bild 1 von 1

Using a soldering iron, solder both red wires to their appropriate connections.
Be extremely careful when using a soldering iron! Contact with the tip could cause severe burns.

Übersetzen