Einleitung

Step by step process on how to remove back housing that must be removed before further internal repairs can be done.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. After removing the back of the phone (not pictured), remove the battery by lifting up from the bottom with your thumb. There will be a groove that allows you to remove the battery with your thumb.
    • After removing the back of the phone (not pictured), remove the battery by lifting up from the bottom with your thumb. There will be a groove that allows you to remove the battery with your thumb.

    Kommentar hinzufügen

  2. Remove the four screws (30 mm long) which hold the front and back half of the unit together using a Phillips #000 screwdriver. There will be one screw in each corner.
    • Remove the four screws (30 mm long) which hold the front and back half of the unit together using a Phillips #000 screwdriver. There will be one screw in each corner.

    Kommentar hinzufügen

  3. Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK an der Kasse
    Kostenloser Versand bei Bestellungen über 20 $
    Verwende den Code BLUEANDBLACK
    • Use a metal spudger to release all of the clips around the phone. These clips are used to hold the front and back panel on the phone together.

    Kommentar hinzufügen

    • After the clips are released, carefully separate the back housing from the phone. Notice the sticker that appears in the red box holds the phone together, but can be peeled apart.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

Riley Casteel

Mitglied seit 26.03.2018

257 Reputation

1 Anleitung geschrieben

Team

IUPUI, Team S1-G3, Harley Spring 2018 Mitglied von IUPUI, Team S1-G3, Harley Spring 2018

IUPUI-HARLEY-S18S1G3

6 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 13

Insgesamt: 90