Einleitung

Follow the remaining steps in this guide in order to locate and replace the speakers locate on the interior bottom of the device housing. Take care not to confuse the speakers with batteries, as they look similar.

Flip the device and lay flat.
  • Flip the device and lay flat.

Kommentar hinzufügen

Remove the four (9 mm) screws with a PH2 screwdriver.
  • Remove the four (9 mm) screws with a PH2 screwdriver.

  • Remove the two (7 mm) located with a PH2 screwdriver.

Kommentar hinzufügen

  • Flip the device over and pry the top off with a plastic opening tool.

Kommentar hinzufügen

  • Remove the ribbon cable connecting the motherboard to the button control board by gently pulling it from its connector.

Kommentar hinzufügen

  • Remove four (6 mm) screws connecting the motherboard using a J0 screwdriver.

Kommentar hinzufügen

  • Remove the two cables connected to the motherboard: black power cable and the red/black fan cable.

  • the black cable requires more force to remove than the other cables.

Kommentar hinzufügen

  • Lift the black latch on the ZIF connector and remove the ribbon cable that attaches the digitizer to the motherboard.

Kommentar hinzufügen

  • Raise motherboard by lifting sideways and then up to avoid the ports.

Kommentar hinzufügen

  • Remove wires attaching the piezoelectric speakers to the motherboard.

Kommentar hinzufügen

  • Remove the five screws securing the black plastic cover with a J0 screwdriver.

  • Lift up and out to remove.

Kommentar hinzufügen

  • Remove the two (3 mm) screws connecting the bracket down and pull out the reflector, using a J0 Philips Head Screwdriver.

Kommentar hinzufügen

  • Slide the mirror straight up to remove.

Kommentar hinzufügen

  • Slide out the power source and disconnect its cables from the power jack and the light.

Kommentar hinzufügen

  • Remove the screws holding down the first speaker with a J0 screwdriver.

  • Remove the screws holding down the second speaker down.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

Ryan Goldin

Mitglied seit 15.02.2018

210 Reputation

1 Anleitung geschrieben

Team

USF Tampa, Team S16-G2, Boczar Spring 2018 Mitglied von USF Tampa, Team S16-G2, Boczar Spring 2018

USFT-BOCZAR-S18S16G2

5 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 4

Letzte 30 Tage: 13

Insgesamt: 102