Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four rubber feet with your fingers.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Trigger battery release by inserting a nylon spudger into the battery release tab.
-
Slide tab and pull upwards on the battery to remove. Use the finger slots near the battery.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four 12.7mm screws under rubber feet with a JIS #0 screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.
-
The back panel should just pop off.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect ribbon cables.
-
Disconnect red and white wired connector for speaker and motherboard battery.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove three 12.7mm JIS #0 screws.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently apply pressure on the right plastic frame by plastic clip marked on the picture.
-
Apply pressure to the bottom of the screen and press it towards you.
-
Remove screen from plastic case.
-