Zum Hauptinhalt wechseln

Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 1, Bild 1 von 1
    • Locate the case cover latch on the back of the computer.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 2, Bild 1 von 1
    • Using your index finger, slide and hold the cover latch down.

    • While holding the latch down, place your other hand flat on the side of the case and firmly shift the side panel to the left until it disengages.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 3, Bild 1 von 1
    • Grab the edge of the panel and slide it away from the case until it is removed.

  4. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 4, Bild 1 von 1
    • Lay the computer flat on it's side so that you are looking down at all of the components.

    • Locate the fan and its black, red, and white power cable.

  5. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 5, Bild 1 von 1
    • Follow the power cable to the motherboard connection and remove it by pressing down on the clip.

  6. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 6, Bild 1 von 1
    • Locate the release clip on the side of the fan and hold it down with your thumb.

  7. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 7, Bild 1 von 1
    • While holding the release clip down, look on the outside of the case where the fan lies.

    • Using the four black notches as a reference, slide the fan towards the open side releasing the fan.

Ziellinie

4 weitere Nutzer:innen haben diese Anleitung absolviert.

Tim

Mitglied seit: 10/12/11

76 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team 6-10, Regan Fall 2011 Mitglied von Cal Poly, Team 6-10, Regan Fall 2011

CPSU-REGAN-F11S6G10

4 Mitglieder

11 Anleitungen geschrieben

Ein Kommentar

Thank you, the pictures are very good. My Dell 4600 had a green baffle that funneled the air through the heat sink fins. There is a little latch at the bottom which allows the this to swing open. Because the back of my PC is full of 13 years worth of cables, I did this without lying the PC down and without disconnecting the fan connector from the mother board. I am amazed at how quiet the PC is now.

pxcozzol - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 4

Letzte 30 Tage: 33

Insgesamt: 5,918