Zum Hauptinhalt wechseln

Einleitung

If you notice your laptop is overheating, then this guide may be able to help. This guide will show you how to replace the fan in a few steps.

Ersatzteile

Keine Ersatzteile angegeben.

  1. WARNING :  Please read the safety  information shipped with your computer and follow the steps in  before working inside your computer . After working inside your  computer, follow the instructions.
    • WARNING : Please read the safety information shipped with your computer and follow the steps in before working inside your computer . After working inside your computer, follow the instructions.

    • Close the computer display and turn the computer over

  2. Remove the ten screws that secure the base cover to the computer base.
    • Remove the ten screws that secure the base cover to the computer base.

  3. Using a plastic scribe (plastic opening tool), pry apart the base cover off the computer base.
    • Using a plastic scribe (plastic opening tool), pry apart the base cover off the computer base.

  4. Before opening device, ensure that all data is backed up on a hard drive to prevent data loss. Loosen and then unplug the hard drive cable.
    • Before opening device, ensure that all data is backed up on a hard drive to prevent data loss.

    • Loosen and then unplug the hard drive cable.

  5. Remove two M2 3mm screws, using the Phillips #1 screwdriver. After making sure all screws are removed. Remove the battery.
    • Remove two M2 3mm screws, using the Phillips #1 screwdriver.

    • After making sure all screws are removed. Remove the battery.

  6. Pry open the two clips. Gently lift the ram stick and pull it out of the motherboard. Gently lift the ram stick and pull it out of the motherboard.
    • Pry open the two clips.

    • Gently lift the ram stick and pull it out of the motherboard.

  7. Unplug the daughter board cable in two places marked in red, then remove it. Unplug the fan cable marked in orange. Unplug the fan cable marked in orange.
    • Unplug the daughter board cable in two places marked in red, then remove it.

    • Unplug the fan cable marked in orange.

  8. Remove 1 MR 3mm screw, using the Phillips 1 screwdriver, on the cooling fan. Remove 1 M2 2mm wafer screw, using the Phillips 1 screwdriver, on the cooling fan. Remove the cooling fan.
    • Remove 1 MR 3mm screw, using the Phillips 1 screwdriver, on the cooling fan.

    • Remove 1 M2 2mm wafer screw, using the Phillips 1 screwdriver, on the cooling fan.

    • Remove the cooling fan.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 1

Letzten 7 Tage: 1

Letzten 30 Tage: 8

Insgesamt: 445