Einleitung

Upgraded RAM can help your computer run smoother. Be cautious when following guide backwards.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Remove the ten 7.9 mm screws with the Phillips #1 screwdriver.
    • Remove the ten 7.9 mm screws with the Phillips #1 screwdriver.

  2. Insert metal spudger into a gap in between the back panel and the back of the screen. Pry off the back panel using the metal spudger as a lever, and remove the back panel by lifting the rest off by hand.
    • Insert metal spudger into a gap in between the back panel and the back of the screen.

    • Pry off the back panel using the metal spudger as a lever, and remove the back panel by lifting the rest off by hand.

  3. Kostenloser Versand für alle Bestellungen über 100 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um
  4. Fold protective flaps to the side on the RAM module located in the upper right corner of the laptop.
    • Fold protective flaps to the side on the RAM module located in the upper right corner of the laptop.

  5. Use the tweezers to push the crimping metal away from the chip. The chip will pop up into an angled position. Remove the chip by pulling at the same angle as the chip with the tweezers. Remove the chip by pulling at the same angle as the chip with the tweezers.
    • Use the tweezers to push the crimping metal away from the chip. The chip will pop up into an angled position.

    • Remove the chip by pulling at the same angle as the chip with the tweezers.

  6. Fold the plastic flap over on the other side. As before, pull the fasteners away from the chip with the tweezers. Remove the chip by carefully pulling it out with the tweezers.
    • Fold the plastic flap over on the other side.

    • As before, pull the fasteners away from the chip with the tweezers.

    • Remove the chip by carefully pulling it out with the tweezers.

  7. When reassembling, you must match the notch in the card with the notch in the connector header shown in red. Doing otherwise will break the stick if forced.
    • When reassembling, you must match the notch in the card with the notch in the connector header shown in red.

    • Doing otherwise will break the stick if forced.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Inaki Madrigal

Mitglied seit: 23.04.2018

607 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team S24-G9, Maness Spring 2018 Mitglied von Cal Poly, Team S24-G9, Maness Spring 2018

CPSU-MANESS-S18S24G9

4 Mitglieder

6 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 13

Insgesamt: 154