Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Flip the laptop over.
-
Slide the latches toward the edges to unlock the battery.
-
Lift the battery out of the laptop.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Loosen the two screws on the access panel using the PH1 head screwdriver.
-
Pry the access panel open with the spudger.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the memory card by pulling apart the latches holding it in place.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the nine 8.65mm screws holding the backplate to the laptop using the PH0 head screwdriver.
-
Remove the four 1.22 mm screws holding the backplate to the laptop using the PH0 head screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Depress (push in, not down) the five tabs at the top of the keyboard and the two on each side of the keyboard using a flat head screwdriver.
-
Pry the keyboard from the laptop using the spudger.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the latch holding down the cable using a flat head screwdriver.
-
Slide the cable out.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disengage both antenna (black and white) cables by lifting them up using the spudger.
-
Unscrew the one 8.65 mm screw holding the wireless card.
-
Remove the wireless card.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the locking tab with the spudger and pull the cable form the locking tab.
-
Repeat with the second locking tab.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four 8.65 mm screws underneath the keyboard plate.
-
Remove the three 1.22 mm small screws underneath the keyboard plate.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Separate the palmrest from the base of the laptop using the spudger to loosen the palmrest along the edges.
-
Make sure to remove all the screws, especially the inconspicuous 8.65 mm screw next to the hard drive.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Tweezers$4.99-
Remove the cables on the upper left side of the laptop using flat tweezers.
-
Remove the cable from the upper right hand corner.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the speaker cable.
-
Remove cable on the right-hand side.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unscrew the one 8.65 mm screw holding the motherboard in place with a PH0 size head screwdriver.
-
Remove the motherboard.
-