Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Before removing the back panel, make sure the device is disconnected from any power source. Make sure that your battery has also been removed.
Was du brauchst
-
-
Use a Phillips #1 screwdriver to remove the two 2.5x8mm screws on the back panel.
-
-
-
-
Place the plastic spudger in the slot. Using the flat side of the spudger pry the back panel upward and off.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.