Einleitung
In this guide, we will be showing you how to remove and replace the Display Assembly.
Was du brauchst
-
-
Note of the routing of the Mini-Card antenna cables and remove them from the routing guides on the bottom of the computer.
-
-
-
Remove the two screws on the bottom of the computer that secure the display assembly to the computer base.
-
-
-
Pull the Mini-Card antenna cables up through the slot in the computer base.
-
-
-
Note the routing of the Mini-Card antenna cables and remove them from the routing guides on the palm rest.
-
-
-
Disconnect the display cable from the connector on the system board, and remove the display cable grounding screw.
-
-
-
-
Hold the display assembly in place and remove the three screws that secure the display assembly to the computer base.
-
-
-
Lift the display assembly off the alignment posts on the computer base.
-
-
-
Use the alignment posts to place the display assembly on the computer base.
-
-
-
Replace the three screws that secure the display assembly to the computer base
-
-
-
Connect the display cable to the connector on the system board, and replace the display cable grounding screw.
-
-
-
Route the Mini-Card antenna cables through the routing guides on the palm rest.
-
-
-
Thread the Mini-Card antenna cables through the slot in the computer base.
-
-
-
Turn the computer over and replace the two screws that secure the display assembly to the computer base.
-