Einleitung

If your palmrest becomes cracked, you'll need to replace the entire palmrest assembly. You'll also need to remove this part to get to the various internals of the computer.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Make sure the laptop is off before attempting to remove the battery.
    • Make sure the laptop is off before attempting to remove the battery.

    • Flip over your laptop so that the battery faces you.

    Kommentar hinzufügen

  2. Slide each latch away from the battery to unlock it.
    • Slide each latch away from the battery to unlock it.

    Kommentar hinzufügen

    • Lift the battery upwards to remove it.

      • Continue holding the latches when removing the battery.

    Kommentar hinzufügen

    • Remove one 4.8mm screw with a JIS #00 screwdriver.

    • Remove the optical drive.

    Kommentar hinzufügen

    • Remove two 4.8mm screws with a JIS #00 screwdriver.

    • Remove the access panel.

    Kommentar hinzufügen

    • Remove three 4.8mm screws from the hard drive with a JIS #00 screwdriver.

    • Slide the hard drive to the left.

    • Slide the hard drive to the right and up.

    Kommentar hinzufügen

    • Slide the two clips away from the RAM.

    • Lift the RAM out.

    Kommentar hinzufügen

    • A metal spudger can scratch delicate internal parts. Be extra careful when removing the keyboard.

    • Use a metal spudger to loosen the main frame of the keyboard.

      • A metal spudger should be used instead of a plastic one because a plastic one will probably break.

      • Make sure to get the spudger under the entire keyboard and not just under the keys.

    Kommentar hinzufügen

    • Slowly lift the keyboard.

    • Lift the locking flap that holds the ribbon cable in place.

      • The white line on this ribbon cable marks the edge of the connection area. To reinstall, insert the cable into the connector up to this line, and then close the locking flap.

    • Remove the keyboard.

    Kommentar hinzufügen

    • Remove two 1.6mm screws from beneath the optical drive with a JIS #00 screwdriver.

    • Remove the eight remaining 4.8mm screws from the back of the computer with a JIS #00 screwdriver.

    Kommentar hinzufügen

    • Remove the two exposed ribbon cables.

    • Remove the palmrest.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Mack Chabot

Mitglied seit 18.10.2017

607 Reputation

6 Anleitungen geschrieben

Team

UMass Dartmouth, Team S3-G7, Bailey Fall 2017 Mitglied von UMass Dartmouth, Team S3-G7, Bailey Fall 2017

UMASSD-BAILEY-F17S3G7

3 Mitglieder

11 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 2

Letzte 30 Tage: 6

Insgesamt: 49