Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
If your Dell Inspiron (17R-N7010) is easily overheating or you don’t hear the fan running when it normally would be, it is time to replace the fan, and this guide will demonstrate how to do so.
The fan protects your computer from overheating and potentially damaging internal components. It is essential that this part be working correctly to lengthen the life of your computer.
Before beginning, ensure that you have a spudger and a Phillips 0 screwdriver, and that your computer is powered off and the battery is removed. Steps 1-6 of this guide are from the Battery Replacement and Palm Rest Replacement guides. These steps must be followed in order to replace the fan safely and correctly.
Was du brauchst
-
-
Flip over the laptop so the back is facing upwards.
-
Locate the battery compartment.
-
-
-
Slide both locks away from the center of the battery.
-
After you hear a click, pull out the battery.
-
-
-
Remove the four screws from the back panel.
-
Flip the laptop over and open it to view the keyboard.
-
Disconnect the keyboard from the laptop by lifting up the latch holding the ribbon cable in place.
-
-
-
-
Close the laptop and flip it over so the bottom is facing upwards.
-
Remove the two screws from the small panel.
-
Remove the small back panel.
-
Slide the CD drive out of the laptop.
-
Remove the three screws from the CD drive slot.
-
-
-
Remove the top cover by inserting a spudger under the surface.
-
Working clockwise, pry upwards with the spudger to detach the clips.
-
-
-
Disconnect the ribbon cables.
-
Remove the cover to access the inner hardware of the laptop.
-
-
-
The fan is located at the top left
-
To remove the fan, disconnect the coupled wires from the white port
-
Then disconnect the wire strip by lifting up the latch holding the wire in place
-
Finally locate and unscrew the screws
-
The fan can now be removed and replaced
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.