Zum Hauptinhalt wechseln

Einleitung

This guide will show you the process of replacing your DigiLand Dl801W power button components. There are quite a few steps, so take your time and follow them carefully.

Note: Light soldering is required for successful repair of the power button components of the DigiLand Dl801W.

  1. Before opening your DigiLand Tablet, ensure that the MicroSD card is removed.
    • Before opening your DigiLand Tablet, ensure that the MicroSD card is removed.

    • Hold the tablet in one hand (not your primary hand) so that the bottom edge of the tablet is facing you and the back of the tablet is facing up.

    • Using a blue plastic opening tool, gently insert the tool between the back panel and the main body.

    • Going around the edge of the tablet, gently pry open the back panel. As you go around, you will hear a click.

  2. Remove the 10 JIS #000 screws from the back of the device.
    • Remove the 10 JIS #000 screws from the back of the device.

  3. MacBook Akku Fix Kits

    Ab $69.99

    Buy Now

    MacBook Akku Fix Kits

    Ab $69.99

    Buy Now
  4. Using a spudger, lift the flaps securing the four ZIF connectors. The smaller of the four flaps may require you to use the point end of the spudger. Use the pointed end of the spudger to disconnect the ribbon cables from their ZIF connectors.
    • Using a spudger, lift the flaps securing the four ZIF connectors.

    • The smaller of the four flaps may require you to use the point end of the spudger.

    • Use the pointed end of the spudger to disconnect the ribbon cables from their ZIF connectors.

    • Be careful not to damage any of the wires. If damaged, the tablet may not work correctly after repairing.

  5. After removing all of the screws and disconnect any wires, use the blue plastic opening tool and starting from the bottom near the battery, carefully lift the back metal plate and motherboard out. Set aside in a secure place.
    • After removing all of the screws and disconnect any wires, use the blue plastic opening tool and starting from the bottom near the battery, carefully lift the back metal plate and motherboard out. Set aside in a secure place.

  6. Disconnect battery terminal using the black spudger. Once the battery is disconnected, the motherboard should lift right off of the metal back plate.
    • Disconnect battery terminal using the black spudger.

    • Once the battery is disconnected, the motherboard should lift right off of the metal back plate.

    • Now you will be able to remove the Power Button and Volume Assembly with a soldering iron.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Travis Mangum

Mitglied seit: 17.09.2015

542 Reputation

4 Anleitungen geschrieben

Team

IUPUI, Team 3-4, Harley Fall 2015 Mitglied von IUPUI, Team 3-4, Harley Fall 2015

IUPUI-HARLEY-F15S3G4

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 6

Letzte 30 Tage: 26

Insgesamt: 1,080