Zum Hauptinhalt wechseln

Einleitung

This guide describes the steps to opening the case.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Remove 2 screws from each side of the amplifier.
    • Remove 2 screws from each side of the amplifier.

  2. Remove 2 screws on rear of device. Slide top cover up and back from main case.
    • Remove 2 screws on rear of device. Slide top cover up and back from main case.

  3. Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
    • Remove 3 screws on bottom of case.

    • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

  4. Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
    • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

    • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Colby

Mitglied seit: 15.04.2010

284 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 28-36, Regan Spring 2010 Mitglied von Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 Mitglieder

3 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 3,432