Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Use this guide to replace a dysfunctional back cover.
Was du brauchst
-
-
Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
-
-
-
On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
-
Pry up the panel; starting from the front/bottom corner, as indicated.
-
There's a concealed lip, under the opposite edge.
-
-
-
-
Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
-
Use tweezers to lift the panel.
-
-
-
Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 3-41, Regan Winter 2011 Mitglied von Cal Poly, Team 3-41, Regan Winter 2011
CPSU-REGAN-W11S3G41
2 Mitglieder
21 Anleitungen geschrieben
