Abbrechen

Disassembling Canon PowerShot SD800 IS Front Cover

Geschrieben von: Jeremy Rabaino (und 2 anderen Mitwirkenden)

Kommentare: 0
Favoriten: 2

Disassembling Canon PowerShot SD800 IS Front Cover

Schwierigkeitsgrad

Sehr einfach

Schritte

7

Zeitaufwand

1 Minute

Einleitung

Removing the front cover allows access to the flash assembly.

Werkzeuge

Diese Werkzeuge kaufen

Phillips #00 Screwdriver

6,99 $

Kaufen

Ersatzteile

Keine Ersatzteile angegeben.

1. Schritt Back Cover

Remove one 2.25mm screw on the bottom.

Remove one 2.25mm screw on the bottom.

2. Schritt

Remove two 2.25mm screws on the right side looking from the front.

Remove two 2.25mm screws on the right side looking from the front.

3. Schritt

Remove one 4.7mm screw on the side with the AV output.

Remove one 4.7mm screw on the side with the AV output.

4. Schritt

Pull off the back cover.

Pull off the back cover.
The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

5. Schritt Front Cover

Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.

Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.

6. Schritt

Remove one 2.25mm screw on the bottom of the camera.

Remove one 2.25mm screw on the bottom of the camera.

7. Schritt

Pull off the front cover.

Pull off the front cover.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Autor

mit 2 anderen Mitwirkenden

Jeremy Rabaino

Mitglied seit: 10.10.2010

135 Reputation

6 Anleitungen geschrieben

Auszeichnungen: 7

+ 4 mehr Auszeichnungen

Team

Cal Poly, Team 20-9, Maness Fall 2010 Mitglied von Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Mitglieder

6 Anleitungen geschrieben

0 Kommentare

Einen Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 2,291