Zum Hauptinhalt wechseln

Disassembling Canon PowerShot SD800 IS LCD Display

Was du brauchst

  1. Disassembling Canon PowerShot SD800 IS LCD Display, Back Cover: Schritt 1, Bild 1 von 1
    • Remove one 2.25mm screw on the bottom.

  2. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 2, Bild 1 von 1
    • Remove two 2.25mm screws on the right side looking from the front.

  3. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 3, Bild 1 von 1
    • Remove one 4.7mm screw on the side with the AV output.

  4. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 4, Bild 1 von 1
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

  5. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Assembly: Schritt 5, Bild 1 von 1
    • Remove 2 2.4mm screws on bottom.

  6. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 6, Bild 1 von 1
    • Follow the small data cable to where it connects to the camera.

    • Lift the back white portion to unlock the cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  7. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 7, Bild 1 von 1
    • Gently lift LCD display off.

    • There will be two data cables still attached to the camera. Do not break them.

    • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

  8. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 8, Bild 1 von 1
    • Follow the larger cable to where it connects to the camera.

    • Lift the front black portion of the connector to unlock the data cable.

    • The cable should easily slide out.

    • The connector is very fragile. Use caution when lifting the lock.

  9. Disassembling Canon PowerShot SD800 IS LCD Display, LCD Display: Schritt 9, Bild 1 von 1
    • Pry the LCD display out from the four metal clamps.

  10. Disassembling Canon PowerShot SD800 IS LCD Display: Schritt 10, Bild 1 von 1
    • To remove the LCD, peel the larger data cable off from the frame.

    • The LCD is glued by its data cable to the back of the LCD frame.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Mitglied seit: 10/10/10

135 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team 20-9, Maness Fall 2010 Mitglied von Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Mitglieder

6 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 2,689