Disassembling Compaq Mini 110 Hard Drive

Geschrieben von: alea (und 5 andere Beteiligte)

Kommentare: 5
Favoriten: 7
Vollendete Reparaturen: 10

Disassembling Compaq Mini 110 Hard Drive

Schwierigkeitsgrad

Einfach

Schritte

Zeitaufwand

1 Minute

Werkzeuge

Diese Werkzeuge kaufen

Ersatzteile

Kein Ersatzteil erforderlich.

Schritt 1 Disassembling Compaq Mini 110 Battery

Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Übersetzen

Schritt 2

Push the tabs inward and slide the battery out.

Push the tabs inward and slide the battery out.

Übersetzen

Schritt 3 RAM

Find and remove the two screws on the bottom of your Compaq Mini covering the memory compartment.

Note that the screws are attached to the panel.

Find and remove the two screws on the bottom of your Compaq Mini covering the memory compartment.
- Note that the screws are attached to the panel.

Übersetzen

Schritt 5 Keyboard

Remove the rubber pads located on the corners of your Compaq Mini.

There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Remove the rubber pads located on the corners of your Compaq Mini.
There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Übersetzen

Schritt 6

Unscrew all the corner screws. There are four total, one under each rubber pad.

Unscrew all the corner screws. There are four total, one under each rubber pad.

Übersetzen

Schritt 7

Unscrew the screw for the bottom case located in the RAM compartment.

Unscrew the screw for the bottom case located in the RAM compartment.

Übersetzen

Falta um passo, pois nos modelos COMPAQ MINI 110, existe um parafuso que segura o teclado, que se encontra bem escondido dentro da cavidade que encaixa a bateria.

Amilcar Correia - 24.05.2011 Antwort

Schritt 8

Remove the three screws in the silver tabs at the back of the keyboard. The red circles show where they are located at the back of the base under the screen.

Remove the three screws in the silver tabs at the back of the keyboard. The red circles show where they are located at the back of the base under the screen.

Übersetzen

3 screws in red circles are actually on metal tabs in the battery compartment, 1 deeper than the other 2. There is a keyboard symbol for each of the 3 screws.

Step 8B: Lift out keyboard by pushing upwards on the 2 accessible metal tabs. This is the most difficult step. Lack of Quality Control during assembly may prevent the kevboard from lifting out without breaking!!

John - 26.05.2012 Antwort

This step may be performed after battery removal. Use care when removing ribbon cable: the white clips holding the black plastic "keeper" are fragile. Reassembly possible without white clips; however, jostling may cause the ribbon to come free.

Jason L - 14.12.2014 Antwort