Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Turn off the camera.
-
Locate the power switch on the front of the camera below the camera lens.
-
Slide the switch to the off position.
-
-
-
Locate the 3 screws that hold the back cover to the camera.
-
One screw is located on the film opener side of the camera.
-
The other screws are located on the opposite side of the camera.
-
-
-
-
Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.
-
-
-
Open the film door to remove the back cover.
-
Slide the film door lever to the left until the film door opens.
-
-
-
Use a plastic opening tool to pry the case open until a small gap is present.
-
Repeat this process at the top and bottom of the film door to loosen it.
-
-
-
Grab the top and bottom of the case firmly as shown.
-
Gently remove the back of the camera case with a slight twisting motion.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
UW Stout, Team 1-2, Zhou Fall 2011 Mitglied von UW Stout, Team 1-2, Zhou Fall 2011
UWSTOUT-ZHOU-F11S1G2
4 Mitglieder
10 Anleitungen geschrieben
