Ersatzteile

Kein Ersatzteil erforderlich.

Turn off the camera.
  • Turn off the camera.

    • Locate the power switch on the front of the camera below the camera lens.

    • Slide the switch to the off position.

Kommentar hinzufügen

Locate the 3 screws that hold the back cover to the camera.
  • Locate the 3 screws that hold the back cover to the camera.

    • One screw is located on the film opener side of the camera.

    • The other screws are located on the opposite side of the camera.

Kommentar hinzufügen

  • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

Kommentar hinzufügen

  • Open the film door to remove the back cover.

    • Slide the film door lever to the left until the film door opens.

Kommentar hinzufügen

  • Use a plastic opening tool to pry the case open until a small gap is present.

    • Repeat this process at the top and bottom of the film door to loosen it.

Kommentar hinzufügen

  • Grab the top and bottom of the case firmly as shown.

    • Gently remove the back of the camera case with a slight twisting motion.

Kommentar hinzufügen

  • Locate the 3 screws on the camera that hold the front cover of the camera to the camera body.

    • The first 2 are located on the bottom of the camera.

    • The last screw is located behind the flash module.

      • Turn the camera on, and raise the flash module to locate the flash module screw.

Kommentar hinzufügen

  • Remove the 2 screws at the base of the camera housing.

    • Use the Phillips #00 Precision Screwdriver and remove the screws.

    • Repeat this process for the screw behind the flash module.

Kommentar hinzufügen

  • Remove the screw located under the flash module using the Phillips #00 Precision Screwdriver.

Kommentar hinzufügen

  • Remove the flash cover.

    • Remove the flash module by twisting it up and outward of the camera housing.

    • The cover can now be be removed.

Kommentar hinzufügen

  • Remove the film door lever.

    • Remove the screw holding the film lever in place by using a Phillips #00 Precision Screwdriver.

    • Using a plastic opening tool, gently pry the switch upwards to remove it.

Kommentar hinzufügen

  • Open the battery door by pushing the lever towards the arrow indicated.

Kommentar hinzufügen

  • Remove the front cover.

    • Insert your thumb in the film hole and gently pry the bottom loose.

    • Once the front is loose, gently pull it out.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

David Cottrell

Mitglied seit 04.10.2011

58 Reputation

5 Anleitungen geschrieben

Team

UW Stout, Team 1-2, Zhou Fall 2011 Mitglied von UW Stout, Team 1-2, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G2

4 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 516