Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Remove the five Phillips #00 bottom and right side panel screws.
-
-
-
Using your thumb and forefinger, pull off the silver name plate and silver "T-shape" piece.
-
-
-
Remove the black front panel by sliding it towards the lens and then pulling it up off of the camera.
-
-
-
-
Remove the three Phillips #00 screws from the front of the camera.
-
Using a spudger, lift the two tabs to separate the case—one tab on top and one tab on the right side.
-
-
-
Using a plastic spudger, lift up the black clips.
-
Still using the plastic spudger, detach the gold connector strip and white connector strip.
-
Using both hands, pull the camera apart into two pieces.
-
-
-
Using a plastic spudger, lift up the black clips.
-
Still using the spudger, detach the three gold wire tape connectors from the inside of the camera.
-
-
-
Using your thumb and forefinger, pull the lens piece straight out from the body of the camera.
-
-
-
Unscrew two screws on the right side of the camera using a #00 screwdriver.
-
-
-
Using a plastic spudger, lift up the black clips.
-
Still using the spudger, detach the gold wire tape connectors from the logic board.
-
-
-
In order to remove the logic board, grab each side of it and pull up using your thumb and forefinger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 13-4, Forte Winter 2011 Mitglied von Cal Poly, Team 13-4, Forte Winter 2011
CPSU-FORTE-W11S13G4
6 Mitglieder
12 Anleitungen geschrieben
