Einleitung

Separating the logic board from the face plate.

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place. Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place. Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.
  • Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.

Kommentar hinzufügen

Remove the top screw on the back panel. Remove the top screw on the back panel.
  • Remove the top screw on the back panel.

Kommentar hinzufügen

Slide off the case to expose the internal components of the receiver. Slide off the case to expose the internal components of the receiver.
  • Slide off the case to expose the internal components of the receiver.

Kommentar hinzufügen

Unscrew the three screws on top of the face plate. Unscrew the three screws on top of the face plate. Unscrew the three screws on top of the face plate.
  • Unscrew the three screws on top of the face plate.

Kommentar hinzufügen

Unscrew the one screw on the bottom of the front panel. Unscrew the one screw on the bottom of the front panel.
  • Unscrew the one screw on the bottom of the front panel.

Kommentar hinzufügen

Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force. Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force. Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.
  • Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.

Kommentar hinzufügen

On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws. On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws. On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws.
  • On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws.

Kommentar hinzufügen

You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up. You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up.
  • You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Ryan

Mitglied seit 13.04.2010

86 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 27-92, Amido Spring 2010 Mitglied von Cal Poly, Team 27-92, Amido Spring 2010

CPSU-AMIDO-S10S27G92

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 8

Insgesamt: 2,150